How to soften 502 glue when it dries?

How to soften 502 glue when it dries? The use of 502 glue is very common. Sometimes we need to soften the dried 520 glue. Let's take a look at the specific operation method below.

How to soften 502 glue when it dries? The use of 502 glue is very common. Sometimes we need to soften the dried 520 glue. Let's take a look at the specific operation method below.

1. You can stick 502 there with a wet hot towel. After ten minutes, the cured 502 will become soft and can be removed. You can also put another drop of 502 on the place where there is 502, and the cured 502 will become soft, so it can be removed with a towel.

2. Use insulating oil, pour some insulating oil in the transformer on the table, the 502 glue will soften quickly and can be rubbed off quickly.

3. Use degelling agent to clean.

4. 502 glue is an instant glue, as long as it uses a dissolved organic solvent, such as acetone. But when using acetone, the operation method must be proper.

5. Stick 502 glue on a small area, soak it in hot water to soften it. If a large area is stained with 502 glue and coated with acetone, it can be removed after about 5-10 minutes.

6. If the conditions are limited, you can use alcohol, white wine or cooking wine, etc., soak the sticky area for 1-2 minutes, and use scissors to carefully scrape it off. How to use 502 glue

1. Clean the adhesive surface first to remove dust, oil, rust, etc. on the adhesive surface.

2. Open the front cover and lightly buckle the top part with your fingers so that no remaining liquid is left, and then cut out the holes with scissors.

3. Put a small drop of glue on the surface to be glued, and immediately proceed to adhesion until the glue hardens, the adhesion area should not be too large, and the thickness of the adhesion layer should not exceed 0.2mm.

4. After using the 502 glue, scrub the 502 glue bottle and cover it, then store it in a cool and dry place.